Toshiba Tecra M2V Maintenance Manual page 120

3 Tests and Diagnostics
3. Select the option you want to execute and press Enter. When "1-SYSTEM TEST" is
selected, the following message will appear:
SYSTEM TEST
SUB-TEST : XX
PASS COUNT: XXXXX
WRITE DATA: XX
ADDRESS : XXXXXX
SUB-TEST MENU :
01 - ROM checksum
02 – Dock/UnDock
03 -
04 – Fan ON/OFF
05 – Gerserville
06 - Quick charge
07 - DMI read
08 - DMI write
09 - CPU Thirmistor
10 –
11 – System LED
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed by your computer may be slightly different from the one
shown above.
4. Select the desired subtest number from the subtest menu and press Enter. The
following message will appear:
TEST LOOP : YES/NO
Selecting YES increases the pass counter by one, each time the test cycle ends and
restarts the test cycle.
Selecting NO returns the subtest menu to the main menu after the test is complete.
3-6
XXXXXXX
XXXX DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break] : test end
[Ctrl]+[C]
ERROR COUNT: XXXXX
READ DATA
TATUS
3.2 Executing the Diagnostic Test
: key stop
: XX
: XXX
TECRA M2V Maintenance Manual (960-476)