Toshiba Tecra M2V Maintenance Manual page 265

4.22 Power switch board
2. Remove the power switch board from the hole.
3. Disconnect the power switch cable from the connector PJ9610 on the power switch
board.
Power switch cable
PJ9610
Power switch board
Installing the Power switch board
To install the power switch board, follow the steps below and refer to the figures 4-45 and 4-
46.
1. Connect the power switch cable to the connector PJ9610 on the power switch board.
2. Install the power switch board in place while passing through the hole.
3. Install the power button holder while hooking the two latches.
TECRA M2V Maintenance Manual (960-476)
Figure 4-46 Removing the power switch board
4 Replacement Procedures
4-65