Toshiba Tecra M2V Maintenance Manual page 79

2.4 System Board Troubleshooting
Table 2-5 Printer port LED boot mode status (4/7)
LED Status
04h BIOS signature check (at Cold
Boot)
05h SMRAM initialization
Check of Wake Up factor
Rewriting of SMRAM base and
storing CPU state map for BIOS
(Enabling SMI only by ASMI)
06h Initialization of a device which
needs initialization before
initialization of PCI bus
07h Storing memory configuration in
buffer
Reading EC version
Update of flash ROM type
Evaluation of destination
(home/overseas) by DMI data
TECRA M2V Maintenance Manual (960-476)
Test item
PIT test (at the Cold Boot) and initialization
Setting of test pattern for PIT#0 of CH0
Check whether the test pattern set can be read.
Initialization of PIT CH0 (Setting of timer interrupt interval
to 55ms)
Initialization of PIT CH2 (Setting of sound generator
frequency to 664Hz)
Test of PIT CH1 (Check whether a refresh signal is
working properly when refresh interval is set to 30ms.
HLT when the time is out.)
Test of PIT CH2 (Check whether the speaker gate is
working properly.)
Measuring of CPU clock
Enabling SMI except for auto-off function
Check of parameter block A
Control of input voltage over rating
Control of battery discharge current
Control of AC adapter over current rating
Division process of measuring IRT time
Setting for clock generator
CPU initialization
Setting of CPU core frequency
Setting of Gsv high and low frequency
Check of Geyserville support
Setting of CPU clock to high
2 Troubleshooting Procedures
Message
2-23