Remote Operation; Changing Transmitter Frequency Setting - Casablanca COTTAGE Owner's Manual

Hide thumbs

Table of Contents

Fan Control

To start the fan. Press the selected speed button to run the fan at the desired speed.

LOW=Low speed MED=Medium speed

To turn oﬀ the fan, press the FAN OFF button.

Airﬂ ow Direction

To reverse the airﬂ ow, press the REVERSE button. REVERSE operates at any speed

whether the fan is on or oﬀ . Th e fan returns to its set speed after reversing.

Light Control

Turn the light on or oﬀ independently from the fan by pressing the LIGHT button. If you

press the button for more than 0.7 seconds, it becomes a dimmer. Th e light varies from

"bright" to "dim" over approximately 8 seconds. If you continue to hold the LIGHT button,

this sequence will reverse when the light reaches its brightest or dimmest level. Release the

button when the desired level is reached.

Auto Resume

Quick (pressing less than 0.7 seconds) on/oﬀ operation of the LIGHT button maintains

the desired brightness level set previously.

CHANGING TRANSMITTER FREQUENCY SETTING

Note: All fans leave the factory set to "00000."

You will only have to change the dip switch settings in the remote

if you are using more than one fan in the same area and want to

control them separately.

Step 1. At the circuit breaker or fuse box, turn the power oﬀ for

the fan you want to change.

Step 2. Open the battery door of the Versa•Touch control and

remove the batteries.

Step 3. Change the dip switch settings, assuring that they are

diﬀ erent from the previously installed Versa•Touch fan.

Step 4. Reinstall the batteries and the battery door on the

control.

Step 5. At the circuit breaker or fuse box, turn the power back on

for the fan whose frequency you are changing.

Step 6. Within 20 seconds of restoring power, push the HIGH,

MED, and LOW buttons (in that order).

Note: You may want to label your controls to assure you

do not mix them up.

If the fan is not functioning after installation:

Step 1. Check to make sure that batteries are installed correctly

in the control.

Step 2. Turn the power oﬀ to the fan (from the circuit breaker)

for at least 5 seconds.

Step 3. Turn the power back on (at the circuit breaker) and push

the HIGH, MED, and LOW buttons–in that order–within 20

seconds. Th e fan should now function properly.