Remote Operation; Changing Transmitter Frequency Setting - Casablanca Isotope Owner's Manual

C30g45h

Hide thumbs Also See for Isotope:

Owner's manual (20 pages)

Owner's manual (16 pages)

Installation instructions manual (20 pages)

Table of Contents

RIME•

OUCH

Fan Control

To start the fan, press the appropriate speed button to run the fan at the desired

speed.

• = lOW speed

•• = MED speed

To turn off the fan, press the Fan OFF button.

Airflow Direction

To reverse the airflow, press the REVERSE button. ReVeRSe operates at

any speed, whether the fan is on or off. The fan returns to its set speed after

reversing.

Light Control

Turn the light on or off independently from the fan by pressing the ligHT button.

if you press the button for more than 0.7 seconds, it becomes a dimmer. The

light varies from "bright" to "dim" over approximately 8 seconds. if you continue

to hold the ligHT button, this sequence will reverse when the light reaches

the brightest or dimmest level. Release the button when the desired level is

reached.

ChaNgINg TraNSMITTEr frEqUENCY SETTINg

note: all fans leave the factory set to "0000."

You will only have to change the dip switch settings in the

remote if you are using more than one fan in the same

area and want to control them separately.

Step 1. at the circuit breaker or fuse box, turn the power

off for the fan you want to change.

Step 2. Open the battery door of the Prime•Touch control

and remove the batteries.

Step 3. Change the dip switch settings, assuring

that they are different from the previously installed

Prime•Touch fan.

Step 4. Replace the batteries and the battery door on

the control.

Step 5. at the circuit breaker or fuse box, turn the

power back on for the fan whose frequency you are

changing.

Step 6. Within 20 seconds of restoring power, push the

HigH, Med, and lOW buttons (in that order).

note: You may want to label your remote controls to

assure you do not mix them up.