Color Adjustment; Dimmer Curves; Control Panel Lock; Program Upload - Chauvet COLORado 3p Tour User Manual

Operation
Programming (Cont.)

Color Adjustment

Dimmer Curves

Control Panel Lock

Program Upload

COLORado™ 3p Tour User Manual Rev. 02c
The COLOR setting determines how the COLORado™ 3p Tour generates the white
color when the Red, Green and Blue faders are all at the "255" value.
1) Go to SETTINGS > COLOR.
2) Select OFF, RGB TO W or UC.
Setting Description
OFF When R, G and B are "255," the output will be at its maximum.
When R, G and B are "255," the CALIBRATION > RGB TO W setting
RGB TO W
will determine the output.
When R, G and B are "255," the output will match that of fixtures from
UC
previous generations.
This setting determines how the output of the COLORado™ 3p Tour follows the position
of the Dimmer fader, as well as the Red, Green and Blue faders.
1) Go to SETTINGS > DIMMER.
2) Select a dimmer curve (OFF, DIM1, DIM2, DIM3 or DIM4).
Setting Description
OFF The output is proportional to the faders' position (linear)
DIM1 The output is not proportional (fastest)
DIM2 The output is not proportional (fast)
DIM3
The output is not proportional (slow)
DIM4 The output is not proportional (slowest)
This setting allows the user to activate or disable the control panel lock, which keeps
non-authorized personnel from changing the fixture's settings.
1) Go to KEYLOCK.
2) Select ON/OFF.
When the control panel lock is active, the fixture will prompt the user to enter the
password after 30 seconds of control panel inactivity or after turning on the
fixture.
After being prompted to enter the password:
1) Press <UP>, <DOWN>, <UP>, <DOWN> and <ENTER>.
This option allows the user to copy the custom programs of one COLORado™ 3p Tour
fixture onto other COLORado™ 3p Tour fixtures by using the Master/Slave method
1) Configure and connect the fixtures in a Master/Slave arrangement, where the
master unit has the custom programs you want to transfer onto the slave units.
2) At the master unit, go to SETTINGS > UPLOAD.
3) Enter the master access password as shown in Control Panel Lock.
45) Wait for the upload process to finish before disconnecting the fixtures.
During and after the upload, the master and slave units will visually indicate the status of
the process, as follows:
Color Meaning
Yellow The upload process is running
Red The upload failed due to an error
Green The upload finished successfully
-12- February 16, 2010