Program Upload; Reset - Chauvet COLORado 1 IP User Manual

Operation

Program Upload

Reset

-12-
This option allows you to copy the custom programs of one COLORado™ 1 IP onto
another COLORado™ 1 IP by using the Master/Slave mode.
1. Configure and connect the products in a Master/Slave arrangement, where the master
product has the custom programs you want to transfer to the slave products.
2. From the master product, go to the SET main level.
3. Select UPLd.
4. When PASS shows, press <ENTER>.
5. Enter the master access password as shown in
6. When SEND shows, press <ENTER> to start the upload.
7. Wait for the upload process to finish (the display will show END/MAIN) before
continuing or turning the products off.
The Master/Slave products will provide the status of the process by lighting up as
follows:
• Yellow indicates that the upload process is running.
• Green indicates that the upload process completed successfully.
• Red indicates that the upload process failed due to an error. Recheck all cable
connections and restart the process. If the issue persists, contact CHAUVET®
Technical Support.
DO NOT upload the data from a COLORado™ 1 IP to a different product. The other
product may become inoperative.
This setting allows you to reset the COLORado™ 1 IP to the default values, including the
custom programs.
1. Go to the SET main level.
2. Select REST.
3. When PASS shows, press <ENTER>.
4. Enter the master access password as described in
5. Wait for the reset process to finish.
Control Panel Lock.
Control Panel Lock.
COLORado™ 1 IP User Manual Rev. 2