Step 4 - Starting The Printer; Host Computer Connection - Compuprint 4247 Serial Quick Setup Manual

Step 4 – Starting the Printer

Host Computer Connection

This printer can be connected to your host computer with the interfaces available
on the Controller Board you have found in the printer box and installed on the
rear of the printer.
There are three types of Controller Boards:
1. Controller Board with a bidirectional IEEE1284 parallel interface, Serial
2. Controller Board with a bidirectional IEEE1284 parallel interface and ASCII
3. Controller Board with a bidirectional IEEE1284 parallel interface and IPDS
Insert the host computer cable(s) into the back of the printer as shown below.
Controller Board with parallel interface and
14
Quick Setup Guide
RS-232/C 9-pin interface and USB 2.0 interface.
Ethernet 10/100 BaseT LAN interface.
Ethernet 10/100 BaseT LAN interface.
DANGER
Switch off printer power and unplug the printer power cord before
connecting or disconnecting a communication port, a teleport, or other
attachment connector.
Ethernet 10/100 BaseT LAN interface.
Controller Board with parallel interface,
Serial interface, and USB interface.