Overview; Figure 2-1: Netaxs™ System Configuration Flow Chart - Honeywell NetAXS User Manual

Configuring via the Web Server

Overview

2.1 Overview
This chapter explains the NetAXS™ configuration functions as accessed via the
NetAXS™ web server. These functions should be performed only by the NetAXS™
system administrator or service personnel.
Caution:
given below is not followed, the NetAXS™ system cannot be successfully configured.
The flow chart in
functions.
Figure 2-1: NetAXS™ System Configuration Flow Chart
2-2 www.honeywell.com
The sequence of NetAXS™ configuration tasks is critical. If the sequence
Figure 2-1 shows the order in which to perform the administrative
Configuration > System > General
Configuration > System > General
Configuration > System > Site Codes
Configuration > System > Host/Loop Communications
Communications Tab, page
Configure the Time Zones
Configuration > Time Management > Time Zones
Configure the Doors
Configuration > Doors > Reader
Configuration > Doors > Output
Configuration > Doors > Inputs
Configure the Access Levels
Configuration > Access Levels
Cards > Add Cards
Assign Access Levels to Cards
Cards > Add Cards
Configure the Panel
(Network Tab, page
(General Tab, page
(Site Codes Tab,
12)
(Time Zones
(Reader Tab,
(Output Tab,
(Inputs Tab,
(Configuring Access
Create the Cards
(Adding New Cards,
(Adding New Cards,
8)
3)
page 9)
(Host/Loop
Tab, page 17)
page 21)
page 28)
page 30)
Levels, page 34)
page 36)
page 36)