Honeywell NetAXS User Manual page 22

Configuring via the Web Server
Configuring the System
Table 2-1: Configuration > System > General Tab Fields (continued)
Parameter
Reset
Cardholder Note 1
Anti-Passback
Gateway Panel Addr
Web Session Timeout
Use PIN
Free Egress
2-4 www.honeywell.com
Description
Reboots the panel. A reset does not change the current
configuration in the database.
Specifies any information field you might want to put on
a card. For example, if you enter "Department" here, a
field labeled "Department" appears on the card. The user
who creates the card would then enter the cardholder's
department name. See Adding New
– Enables anti-passback, which prevents an
Enabled
entrant to an area from passing his card back to another
potential entrant.
– Enforces anti-passback only at doors configured
Local
locally to the panel controlling the original card read.
Global – Enforces anti-passback at panels throughout the
NetAXS™ system after a successful card read at any one
of the system's readers.
– Causes all system codes to be reset at
Forgiveness
midnight every day. This enables a cardholder who exited
the building in the evening without using his card to use
his card for entry the following morning.
Sets the panel address of the Gateway panel, or the panel
directly connected to the host system.
Disabled – Disables the timeout.
___ Minutes – Activates a web session timeout after the
specified number of minutes has elapsed.
Enabled – Requires a valid PIN verification.
– Configures the panel for free egress. Reader 1
Enabled
activates output 1, reader 2 activates output 2, reader 3
activates output 3, and reader 4 activates output 4. Inputs
1, 3, 5, and 7 are egress defaults that activate outputs 1, 2,
3, and 4, respectively. Inputs 2, 4, 6, and 8 are status
defaults for outputs 1, 2, 3, and 4, respectively.
Cards, page 36.