Connecting To The Netaxs™ Web Server; Figure 1-1: Netaxs™ Web Server Hub Connection - Honeywell NetAXS User Manual

Connecting to the Web Server
Connecting to the NetAXS™ Web Server
1.2 Connecting to the NetAXS™ Web Server
This section describes how to connect a computer to the NetAXS™ web server via
Ethernet and Internet Explorer.
Notes:
• The NetAXS™ panel that you are connecting to the computer is the Gateway
• The Microsoft Windows™ screen captures used in this section reflect the
Perform the following steps:
1. Connect your computer's Ethernet port and the NetAXS™ panel's Ethernet
1-2 www.honeywell.com
panel. DIP switch 6 on a Gateway panel must be set to ON for a successful
connection.
Windows 2000™ platform. If you are using another Windows™ platform, the
screens will be somewhat different.
Port by using either of two methods:
a. Connect both the computer's Ethernet port and the NetAXS™ panels
Ethernet port to an Ethernet hub with standard straight-through Ethernet
patch cables.
Figure 1-1: NetAXS™ Web Server Hub Connection
Terminal
Ethernet
Cable
Ethernet Hub
b. Connect the computer's Ethernet port directly to the NetAXS™ panel's
Ethernet port with an Ethernet crossover cable.
cable that maps all output signals on one connector to the input
signals on the other connector. This allows the computer and the
NetAXS™ panel to perform full-duplex Ethernet communication
through an Ethernet hub or switch.
Ethernet Port
Ethernet Port
NetAXS Panel
A crossover cable is a