Master Arm ? (Command + 1) - Bosch Security System User Manual

MASTER ARM ? (COMMAND + 1)

Description
Use this function to turn on the entire system, both
perimeter and interior. When you turn the system on,
the display shows how many seconds of exit delay time
you have to exit the protected area. You should leave
before exit delay time expires.
Leaving after exit delay has expired will cause the entry
delay to start only if the person exits through a point set
for Entry/Exit delay. Exiting through any other point
should cause an immediate alarm. You may also cause
an alarm on an interior device. Enter your personal
passcode to disarm the system.
Your cleaning service, a serviceman, or others may also
use this function to turn on your system when they
leave.
4998122475C
MASTER ARM ? (COMMAND + 1)
Using Master Arm:
Note: Using the COMMAND +1 shortcut will only
arm the area where the keypad has been
assigned. For example, if the command center is
assigned to Area 1, only Area 1 will be armed
when COMMAND + 1 is pressed.
1. The display
shows disarmed
idle text.
2. Press the COMMAND key.
3. The display
shows *System
Command*.
4. Press the 1 key.
Security System User's Guide
Part II: System Commands