Bosch Security System User Manual page 63

PERIMETER PARTIAL ? (COMMAND + 8)
Partially Turn On the Perimeter
Description
This function is used to turn on the perimeter of your
building while selected portions of the perimeter
remain turned off. Perimeter points that are not secure
(faulted) when this function is entered are
automatically bypassed and are not included in the
system. This function does not turn on the interior of
your building. Entry/exit delays are provided with this
arming command.
Use this function in residential systems to turn on the
front of your house while the interior and the rear
perimeter doors are left turned off, giving you freedom
of movement between the house and patio.
In commercial systems, when you need access to the
large overhead doors to receive deliveries, using this
function will allow you to keep the rest of the building
perimeter armed.
4998122475C
PERIMETER PARTIAL ? (COMMAND + 8)
Using Perimeter Partial:
1. Ensure your
command center
shows idle
disarmed text.
Before using this function, decide which
points are to be left turned off. Fault the
points (doors and windows) by leaving them
open. The points must remain open until after
the exit delay time expires.
2. Press the COMMAND key.
The display shows
*System
Command*.
3. Press the 8 key.
Security System User's Guide
Part II: System Commands