Canon Color imageRUNNER LBP5975 User Manual page 454

Cause 3 When the UFR II printer driver was not used, custom size paper was
loaded in landscape orientation to be printed.
Remedy Load the paper in portrait orientation, then print again.
Cause 4 CHK PAPER SIZE in the USER MAIN. options in the SETUP is set to ON.
Remedy Set CHK PAPER SIZE (See p. 5-69) to OFF, then print again.
<52 RAST.MODE ERR>
Cause The printer received data in format that it does not support during printing
in the Raster mode.
Remedy 1 The printer continues printing by pressing [Online]. However, the data may not
be printed properly.
Remedy 2 Print again from the printer driver for LBP5975/5970.
<53 SEC.PRINT ERR>
Cause 1 Secured print data is sent from a printer driver that is not for LBP5975/
5970.
Remedy Perform a soft reset using the RESET menu to delete the print data.
Cause 2 The printer received secured print data when the hard disk cannot be
used.
Remedy Press [Online] to cancel printing, set HARD DISK (See p. 5-25) in the
CONTROL MENU options in the SETUP menu to ON, perform a hard reset,
and then print again.
Cause 3 The number of the jobs exceeded the amount of jobs the printer can save
as secured print jobs (You can save up to 8 secured print jobs in the hard
disk.)
Remedy Press [Online] to cancel printing, delete any unnecessary secured print jobs,
and then print again.
Cause 4 The amount of the job data exceeded the amount of job data that you can
save on the hard disk as secured print jobs (You can save the data in total
of up to 4GB of secured print jobs, stored jobs, and paused jobs in the
hard disk. However, when SECURED TYPE in the CONTROL MENU
options is set to PDL, you can save only up to 1.88GB of data.
Remedy Press [Online] to cancel printing, resume any paused jobs or delete
unnecessary secured print jobs, and then print again.
<Auto Error Skip>
<Auto Error Skip>
Message List 7-41
7