Turning the Printer OFF
Turn the printer OFF using the following procedure. Turn the printer OFF using the
following procedure. The procedure for turning the printer OFF is different between
when a hard disk is used and when it is not used.
IMPORTANT
When using the hard disk, be sure to turn the printer OFF as the procedure for the
•
protection of the hard disk. (See p. 2-4)
2
If the printer is connected to a network, make sure that other computers are not sending
•
print data to the printer before turning the printer OFF.
If you turn the printer OFF when the Job indicator is on, all the print data remaining in the
•
printer memory will be erased. If there is any necessary print data remaining in the
printer, wait until it is output, or press [Reset] in the offline state and then select FORM
FEED to output the data before turning the printer OFF. (See p. 2-60)
Do not turn the power OFF when the printer is in any of the following status:
•
- During printing
- While the printer is running a self-diagnostic test immediately after turning the power
- While a message informing you that the NVRAM is being initialized or being written is
- While <02 STARTING UP> or <02 CALIBRATING> is displayed
When you are using a hard disk, make sure that the HDD indicator is not on. If you turn
•
the printer OFF while the HDD indicator is on (while data is being read from the hard disk
or being written to the hard disk), the hard disk may be damaged and disabled.
When Not Using a Hard Disk
When you are not using a hard disk, turn the printer OFF using the following
procedure.
1
2-4
Turning the Printer ON/OFF
ON
displayed
Make sure that the Job indicator is off.
Cancel Job
Online
Feeder Selection
Utility
Ready
Message
HDD
Job
Off
Job
Power
Settings
OK
Main Power
Reset