Problems With The Printout Results - Canon Color imageRUNNER LBP5975 User Manual

When you print using the stapling function, the edges of the stapled paper are
misaligned, or the printed paper is not stapled properly. (LBP5975 Only)
Cause The following causes are conceivable.
- Diagrams, photographs, or others for which a layer is specified are in the area
of 5 cm or less from the rear edge of the paper (toward the feeding direction).
- Diagrams, photographs, or others for which a layer is specified are on
surfaces overlie each other (ex: on page 2 and page 3) on 2-sided printing.
Remedy Set SPECIAL MODE Q in the USER MAIN. options in the SETUP menu to ON,
and then print again.
IMPORTANT
If SPECIAL MODE Q (See p. 5-70) is set to ON, the printing speed drops when you print
paper using the stapling function.
(10 pages/min for 1-sided printing (Letter); 4 pages/min for 2-sided printing (Letter))

Problems with the Printout Results

Unreadable characters are printed.
Cause 1 The data is printed from Windows without the supplied printer driver
installed for Windows.
Remedy Install the supplied printer driver for Windows, then print again. (See Driver
Guide)
Cause 2 The printer setting in the DOS application is not appropriate.
Remedy Specify the printer setting in the DOS application to the one that is compatible
with this printer. (See Driver Guide)
A blank page cannot be printed.
Cause PAPER SAVE is set to ON.
Remedy When printing a blank page, set PAPER SAVE (See p. 5-75) and (See p. 5-81)
to OFF.
When You Cannot Obtain Appropriate Printout Results
7
7-63