Powering On The Projector; Powering Off The Projector - Panasonic PT-CW330EA Operating Instructions Manual

Powering ON/OFF

Powering On the Projector

1 ) Connect the power plug to the power outlet.
Enter Standby status when the <ON(G)/STANDBY(R)> indicator is lighting / flashing in red.
z
2 ) Press the <
When the <ON(G)/STANDBY(R)> indicator lights up green, the lamp is on.
z
Startup screen is displayed for about 10 seconds, then the image will be projected.
z

Powering Off the Projector

1 ) Press the <
The following message appears.
z
Message will disappear after about 30 seconds when there is no operation.
z
2 ) Press the <
The projection stops and the <ON(G)/STANDBY(R)> indicator on the projector flashes up in red. (Fan is
z
still spinning.)
3 ) Wait until the <ON(G)/STANDBY(R)> indicator lights / flashes up in red (The fan stops
spinning).
The projector enters standby mode when the <ON(G)/STANDBY(R)> indicator lights / flashes up in red.
z
Note
Do not turn on the power and project images immediately after turning the projector off. Turning on the power while the
z
lamp is still hot may shorten the lamp life.
32
- ENGLISH
> button on the control panel or the remote control.
> button on the control panel or the remote control.
> button again.
OR