Table of Contents
Advertisement
*1 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off)
*2 The indicator flashes in the cycle: 2.75 seconds (light) → 0.25 seconds (off)
*3 The indicator flashes in the cycle: 2.0 seconds (light) → 2.0 seconds (off)
*4 The indicator flashes in the cycle: 0.5 seconds (light) → 0.5 seconds (off)
Note
f While the power indicator <ON (G)/STANDBY (R)> lights orange, the fan is running to cool the projector.
f For about 90 seconds after the projector is switched off, the luminous lamp does not light up even if the power is switched on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks red.
f The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks red). Refer to "Power
consumption" (x page 133) for the power consumption.
Powering on the projector
Before switching on the projector, make sure the projector and the external devices are correctly connected
Æ
(
page 31).
2)
1)
1)
Connect the power cord to the projector body.
2)
Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights or blinks red, and the projector will enter the standby
mode.
3)
Press the power <v/b> button.
f The power indicator <ON(G)/STANDBY(R)> lights green and the image is soon projected on the screen.
Note
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longer
before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.
When the initial setting screen is displayed
When the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the
[PROJECTOR SETUP] menu is executed, then the initial setting screen is displayed. Set them in accordance with
circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <MENU> button while the [INITIAL SETTING] screen is displayed, you can go back to the
previous screen.
Same operation is available by pressing the <RETURN> button.
Note
f When the projector is used for the first time, in order to clearly display the menu screen, it may be necessary to adjust the focus ring in the
projection lens area of the projector (x page 24). For details, refer to "How to adjust the state of the image" (x page 41).
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [LANGUAGE] menu.
36 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
3)
3)
INPUT
VOL-
VOL+
AV MUTE
Advertisement
Table of Contents
