Connecting The Srx240 Services Gateway To The Cli - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide
Related
Documentation

Connecting the SRX240 Services Gateway to the CLI

64
Figure 17: Connecting to the Ethernet Port on an SRX240 Services Gateway
If the services gateway has not already been powered on, power it on now.
Wait until the Status LED on the front panel of the services gateway turns steadily
5.
green.
Turn on the power to the management device. The services gateway assigns an IP
6.
address to the management device within the
management device is configured to use DHCP.
To access the setup wizard, open a Web browser on the management device and
7.
enter the IP address 192.168.1.1
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
Setup Wizard on page 75
Connecting the SRX240 Services Gateway to the CLI on page 64
Connecting to the CLI at the User End for the SRX240 Services Gateway on page 69
Connecting the Modem at the SRX240 Services Gateway End on page 67
Connecting the Modem to the Console Port on the SRX240 Services Gateway on
page 68
This topic includes the following sections:
Connecting the Services Gateway to the CLI Locally on page 65
Connecting a Services Gateway to the CLI Remotely on page 66
192.168.1.0/24
in the address field.
Copyright © 2013, Juniper Networks, Inc.
subnetwork if the