Juniper SRX240 Hardware Manual page 98

SRX240 Services Gateway Hardware Guide
Related
Documentation
84
Table 30: Optional Setup Fields (continued)
Field
Configure Interfaces
Configure System: Time
After you configure basic setup, the Setup wizard is no longer available, unless you reset
the device to the factory default and reboot it. To make changes to the configuration,
use the J-Web interface or the command-line interface (CLI).
You can use other wizards to configure basic firewall policies, VPN settings, and NAT
rules. Choose Configure > Wizards to use the available wizards. Use the J-Web interface
or the CLI for more extensive configuration.
For more instructions on managing users and operations, monitoring network performance,
upgrading software, and diagnosing common problems on an SRX240 Services Gateway,
see the following guides:
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
Connecting to the SRX240 Services Gateway Setup Wizard on page 63
SRX240 Services Gateway Software Configuration Overview on page 71
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 78
SRX240 Services Gateway Secure Web Access Overview on page 85
Function
Current System Time
Time Zone
NTP Servers
Copyright © 2013, Juniper Networks, Inc.
Your Action
Use buttons to add, edit, or
delete interfaces other than
VLANs.
NOTE: Make sure that you
have selected the required
services and protocols under
Services (Inbound) and
Protocols (Inbound). Select all
to permit all protocols and
services.
Use Reset Manually button to
reset the time.
Choose the time zone from the
list
Add Network Time Protocol
(NTP) servers that the gateway
can reach to synchronize the
system time.