Juniper SRX240 Hardware Manual page 116

SRX240 Services Gateway Hardware Guide
Related
Documentation
102
Table 33: SRX240 Services Gateway Chassis Alarm Conditions and
Corrective Actions (continued)
Component Alarm Condition
Mini-Physical A Mini-PIM has
Interface failed.
Module
(Mini-PIM)
Hardware The services
components gateway chassis
on the temperature is too
services warm.
gateway
The services
gateway fan has
failed.
The services
gateway
temperature is too
high, either because
of an internal
overheating
condition or because
the maximum
recommended room
temperature has
been exceeded.
Monitoring the SRX240 Services Gateway Chassis Using the CLI on page 95
Monitoring the SRX240 Services Gateway Components Using LEDs on page 97
Monitoring the SRX240 Services Gateway Power System on page 103
Juniper Networks Technical Assistance Center on page 106
SRX240 Services Gateway Chassis on page 7
Clearance Requirements for Airflow and Hardware Maintenance on the SRX240 Services
Gateway on page 34
Action
Contact JTAC. See "Juniper Networks
Technical Assistance Center" on page
If you must replace the failed Mini-PIM, see
the SRX Series Services Gateways for
the Branch Physical Interface Modules
Hardware Guide
for information about
replacing the Mini-PIMs.
Check the room temperature. See
"SRX240 Services Gateway Chassis" on
page 7.
Check the air flow. See "General Site
Guidelines for Installing the SRX240
Services Gateway" on page
Check the fans. See "SRX240 Services
Gateway Cooling System" on page
Contact JTAC for support. See
Networks Technical Assistance Center" on
page 106.
Use the CLI command
show chassis
environment to determine whether the fan
is functioning normally.
If fan has failed, contact JTAC for support.
See "Juniper Networks Technical
Assistance Center" on page
The services gateway shuts down
automatically in 4 minutes.
Copyright © 2013, Juniper Networks, Inc.
Alarm
Severity
Red
106. (major)
Yellow
(minor)
32.
21.
"Juniper
Red
(major)
106.
Red
(major)