Juniper SRX240 Hardware Manual page 61

Replacing or Installing Mini-Physical Interface Modules in the SRX240 Services Gateway
Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
SRX240 Services Gateway Installation Safety Guidelines and Warnings on page 116
Mini-Physical Interface Modules (Mini-PIMs) are circuit boards that you can install in a
device for enhanced functionality based on your requirements. They enable you to easily
add or change physical interfaces on a device.
The Mini-Physical Interface Module (Mini-PIM) slot is covered with a blank faceplate to
maintain proper airflow through the services gateway. Before installing the Mini-PIM, you
must remove the faceplate.
See the SRX Series Services Gateways for the Branch Physical Interface Modules Hardware
for information about installing the Mini-PIMs.
Guide
NOTE: The Mini-PIMs available on the SRX240 Services Gateway are not
hot-swappable. You need to power off the device before removing or installing
Mini-PIMs.
SRX240 Services Gateway Installation Safety Guidelines and Warnings on page 116
Required Tools and Parts for Installing and Maintaining the SRX240 Services Gateway
on page 39
Installing the SRX240 Services Gateway on page 44
Chapter 9: Installing the SRX240 Services Gateway
47