SRX240 Services Gateway Hardware Guide
52
Figure 13: DC Power Feed on SRX240 Services Gateway with DC Power
Supply Model
LEDs
Terminal
block cover
Remove the screws on the terminals using the Phillips (+) screwdriver, number 1. Save
3.
the screws.
WARNING:
Ensure that the power cables do not block access to the device
or drape where people can trip on them.
Connect the power feed to the power sources as shown in
4.
power source cables to the power feed on the device by screwing the ring lugs attached
to the cables to the appropriate terminals by using the screw from the terminals.
Terminal block
Copyright © 2013, Juniper Networks, Inc.
Figure 14 on page
53. Secure