SERVICE WORK ON THE CHASSIS
Removing the lower triple clamp
10.13
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
–
Install the front fender. (
–
Refit the headlight mask with the headlight. (
100802-13
–
Install the front wheel.
–
Check that the wiring harness, cables, and brake and clutch lines can move freely
and are routed correctly.
–
Check the steering head bearing play. (
(EXC EU/AUS)
x
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
–
Remove the front fender. (
–
Remove screws
Info
Do not unplug the CDI control unit.
–
Remove screw
bar and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
500149-10
them.
Do not bend the cables and lines.
–
Remove protector ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
500150-10
M8
.
p. 52)
(
p. 73)
x
p. 50)
(
p. 44)
x
p. 52)
and hang the CDI control unit to the side.
. Loosen screw
. Take off the top triple clamp with the handle-
.
.
25 Nm
Loctite
®
243™
(18.4 lbf ft)
p. 81)
p. 80)
48
.