SERVICE WORK ON THE CHASSIS
Installing the fork protector
10.10
Removing the lower triple clamp
10.11
Removing the lower triple clamp
10.12
x
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
–
Install the fork legs.
101327-10
(XCF‑W, EXC‑F EU, EXC‑F AUS)
x
–
Remove the fork legs. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
–
Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws
–
Remove screw
and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
101328-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
101329-10
(EXC-F SIX DAYS)
x
–
Remove the fork legs. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
–
Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws
–
Remove screw
dlebar and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
101335-10
M6
M6
(
p. 44)
x
p. 43)
p. 51)
and hang the voltage regulator to one side.
and screw
. Take off the upper triple clamp with the handlebar
. Remove protective ring
p. 43)
p. 51)
and hang the voltage regulator to the side.
. Remove screw
, take off the upper triple clamp with the han-
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
.
45
.