ELECTRICAL SYSTEM
Checking the headlight adjustment
13.10
A
0 0 A
Adjusting the headlight range
13.11
Changing the speedometer battery
13.12
–
Stand the vehicle upright on a horizontal surface in front of a light wall and make a
mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
B
0 0 B
–
Position the vehicle vertically at a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight adjustment.
The border between light and dark must be exactly at the lower mark when the
motorcycle is operational and complete with rider.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. (
–
Check the headlight adjustment. (
–
Loosen screw
–
Adjust the headlight range of the headlight by moving it up or down.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with a rider (mark is applied under: Checking the headlight setting).
Info
A change in weight on the vehicle may require a correction of the headlight
range.
301251-10
–
Tighten screw
–
Remove the headlight mask with the headlight. (
–
Remove screws
–
Pull the speedometer out of the bracket from above.
100859-10
–
Using a coin, turn locking cap
–
Remove speedometer battery
–
Insert the new battery with the label facing upward.
–
Check that the O-ring of the locking cap is seated properly.
100860-10
under the first mark.
p. 82)
p. 82)
.
.
.
counterclockwise all the way and remove it.
.
5 cm (2 in)
in front of the wall.
5 m (16 ft)
p. 80)
82