Troubleshooting Guide - TechniSat DigiCom 1A Instruction Manual

Table of Contents

Advertisement

Power supply:
Mains switch:
Power usage:
<24 W (in operation, horizontal polarisation, 400 mA supply to LNB)
<15 W (in operation, excluding LNB)
< 5 W (in standby mode)
Mains voltage:
180 V....250 V /50 Hz AC
General:
Ambient temperature
Humidity
Dimensions (WxDxH)
Weight

10 Troubleshooting Guide

Problem
No picture, no sound,
Display off
No picture, no sound,
Display on
Picture shows intermittent blocks.
May switch to still image, no
sound, at times screen black and
note "No signal"
Sound OK, screen blue
Sound OK, no picture
+ 15° C ....+ 35° C
< 80 %
305 mm x 135 mm x 65 mm (DigiCom 1A)
305 mm x 270 mm x 65 mm (DigiCom 1 plus)
0.8 kg
Possible Cause
No power
Short circuit in LNB connection
Defective or missing cable
connection
LNB defective
Wrong external unit set on recei-
ver
Dish positioned incorrectly
Heavy rain or snow
Dish positioned incorrectly
Dish too small for this location
Obstruction between dish and
satzellite
Radio mode selected
SCART connector not properly
inserted
Check power plug and cable
Switch receiver off,repair short,
switch receiver on again
Check all cable connections
Replace LNB
Correct setting (see point 5.4)
Correct dish position
Clear dish of snow
Correct dish position
Use larger dsh
Mount dish with unterrupted view
Switch to TV mode
Check SCART connections
44
Solution

Advertisement

Table of Contents
loading

This manual is also suitable for:

Digicom 1 plus

Table of Contents