TechniSat DigiCom 1A Instruction Manual page 28

> Press the
Timer.
The timer can be programmed as follows:
> Use the
> Use the
gramme
> Use the
> Use the
> Repeat the steps shown under "Start" to enter the time when the timer should stop,
i.e. be switched off.
> Use the
> If required, switch the timer on by pressing the
> By repeatedly pressing the
Display:
again to display the menu for Programming the
to mark the
to enter the date on which you wish to record a pro-
to mark the
to enter the starting time for the timer.
to mark the column
key you can set the timer for further days as follows:
Timer off
Timer on
Daily repeat
Repeat once per week
Repeat every two weeks
Repeat every 3 weeks
Repeat every 4 weeks
Repeat only on workdays
Repeat only on weekends
column.
column.
key (Display
28
).