Table of Contents
Advertisement
>
You may now proceed to use the
channels. Press the
(cross appears in display) or to delete a channel from the guide (cross disappears
from display).
>
Use the
>
Use the
>
When you have completed programming the EPG in this manner, press the
key to return to the previous menus.
Or
>
Press the
The data/settings will be automatically stored in memory
Once you have customized the Electronic Programme Guide to your personal preferences,
the process of data acquisition by the EPG can be started manually as follows:
>
Use the
>
Press the key
>
The receiver will now carry out the data acquisition procedure. This is shown in the
display by the letters
>
The data acquisition process can be interrupted by switching on (
the receiver.
7.6
Unblocking the parental lock for individual channels
Enter your PIN in order to get to the appropriate menu, then proceed as described in Point
7.3, removing individual red crosses by pressing the
nels can again be excluded from the parental lock control.
7.7
Programme Search
As mentioned previously, your receiver has been pre-programmed to receive signals from
theASTRA and EUTELSAT satellites. In order to add new channels, or those received from
other satellites, there are four possibilities of carrying out a programme/channel search.
Please note that your Basic Settings (5.2 - search mode) will determine whether only
to-air or
(free-to-air and scrambled) channels will be searched.
All satellites and transponders selected will be searched.
Choose this option to find specific channels or bouquets.
Choose this option to scan a specific transponder of a specific satellite. You can search for
all or selected programmes of a particular transponder.
This option is intended specifically for cases where the desired channel could not be found
by any of the other options. Please note that to utilise this search method, you will have to
enter the specific Service ID Number of the channel, which you can obtain from the broadca-
ster, or from the Internet.
Once the search has been completed, the number of channels identified by your receiver will
be displayed on your screen, also stating how many of these are new channels. New chan-
nels are shown in red type in the Total List, and can be transferred to the User List in accor-
key to add a channel to the Electronic Programme Guide
to move around the list one line at a time.
to move around the list one page at a time.
key to resume normal operation.
to switch the receiver off (standby).
within 5 seconds.
.
in order to select/mark individual
key. In this manner, individual chan-
34
)
-
Advertisement
Table of Contents
