Transponders - TechniSat DigiCom 1A Instruction Manual

A selection window will appear with the four available satellite positions.
> Use the
> Confirm with the
> Use the
> Press again to start the search.
> The search can be terminated at any time by pressing
It is quite likely that a full scan may take 15 minutes or longer.
Please note any notes and information displayed on the screen.
7.7.3 Transponder
This search mode can be used to search a specific transponder (see Point 9: Technical
Terms) for channels. In order to use this function, you will have to enter data relating to the
transponder.
> Use the
> Confirm with the
The menu
In this line you must select the satellite corresponding to the selected transponder.
> Use the
> Press to display a table listing four satellites.
> Use the
> Confirm with the
The selected satellite has now been acquired by the menu.
> Use the
> Use the
> Use the
> Use the
desired programme is broadcast.
The symbol rate indicates the volume of data transmitted per second. An example might be
27500, indicating transmission of 27500 symbols per second.
> Use the
key.
key.
key.
to enter the correct frequency in this line.
key to enter the polarisation plane ( orizontal or ertical) on which the
to select the satellite.
to mark the entry Start search.
to select the Transponder option.
will be displayed.
to select the
to mark the selected satellite.
to mark the entry
to mark the entry
to mark the entry
36
.
option.
.
.
y.