Overview Of Epg - TechniSat DigiCom 1A Instruction Manual

> Use the
> Press the
The selected entry will now be displayed in red.
Your receiver will be switched on at the time when the selected programme is due to
begin.
If the receiver is switched on by the timer, the letter " " will be shown on the display,
together with the channel number. In this mode, most of the functions of the remote
control are disabled in order to prevent an accidental premature interruption of the
recording.
If the receiver is in standby mode, the activated timer will be indicated by blinking of
the two dots (colon) in the time display.
> Press the
Disabling the timer function
If you want to cancel a timer command entered via the EPG, repeat the above steps, then
cancel the timer setting by pressing the
In order to interrupt/disable while the timer is actively in operation, switch off the receiver by
means of the
ched on, and you can continue with normal operation.
6.12.7.4 EPG Survey
You can use the EPG Survey in order to display the current day's programme of a single
channel. This can be done as follows:
> Press the
The EPG table "
> Press the
The table EPG Survey will be displayed.
> Use the
> If available, the
tents for the next few days.
to mark the selected programme.
y.
key to return to the previous display.
. When you press this key again, the receiver will be swit-
.
" will be displayed
.
to select the required programme resp. time.
.
can be used to display the programme con-
25