Do Not Disturb (On Call) - Xblue Networks Xplus100 User Manual

Telephone Operation
• At any time while your Digital Speakerphone is idle, you can immediately divert an incoming
tone ringing intercom call to the attendant by using the Do Not Disturb feature – Forced Inter-
com Call Forward.
• Extensions with a DSS/BLF button of an extension that is in DND, the button will flash.
• The Do Not Disturb feature code can be programmed on a flexible programmable Button,
which will light steady whenever Do Not Disturb is active.
Do Not Disturb (On Call)
Feature Code: Feature
4
Description
The On Call Do Not Disturb feature, allows you to block a ringing outside line while you are on a
call. At the end of the call, you must remember to dial the DND code,
DND feature.
Default Settings:
N/A
Operation
1. While connected on a call, it is possible for an additional call to ring at the extension. To
cancel ringing for additional calls, press a pre-programmed Feature/DSS Button designated
as DO NOT DISTURB
2. Do Not Disturb (On Call) is activated.
3. DND must be disabled after the call, or the extension will remain in Do Not Disturb.
Operational Notes
• The Do Not Disturb (On Call) feature code may be programmed on a Feature/DSS Button.
• A Feature/DSS Button programmed for the Do Not Disturb code will flash at a fast rate while
Do Not Disturb is active.
50
or press Feature 4.
XBLUE Networks
Feature
4 to turn off the