Mechanical Installation; Figure 3-1. Pass-Thru Mechanism External Parts - Compaq SW TL881 DLT Mini-Lib/1 Manual

3-4 Compaq TL881 Minilibrary System Users Guide
8
5
7
6
6
8
8

Figure 3-1. Pass-Thru Mechanism External Parts

Motor drive section
Extension sections
Pass-Thru base with idler
pulley
Tie bars
NOTE: The slide extensions,
mechanism parts. They are supplied as part of the installation hardware for the slides that
come with each of the modules.
Follow the instructions in the section entitled Mechanical Installation of the
Expansion and MiniLibrary Base Modules. After the rack slides and the
MiniLibrary Base Modules are in place, and after the Pass-Thru mechanism is
assembled, you will install the Pass-Thru mechanism in the rack by attaching
5
the support braces to the slide extensions
8
L-shaped nut plates .
The internal parts you will need to recognize during assembly are shown in
Figure 3-2 Figure 3-3.
5
4
6
5
4
Support brace
Left and right rack slide
extensions
Angle brackets
L-shaped nut plates
in Figure 3-1, are not enclosed with the Pass-Thru
6
using the angle brackets
1
2
4
3
8
SHR-1233
7
and