Compaq SW TL881 DLT Mini-Lib/1 Manual page 144

Table 6-2
Fault Symptom Codes
continued
2001 Ctl Invalid Command
2002 Undefined Config
2003 Invalid Drive State
2004 Loader Not Ready
2005 SCSI Id Not Set
2006 DLT Comm Open Error
2007 Door Fault
2008 Illegal Move
2009 Door Open
200A Menu Mode
200C Cart Unaccessible
200D Drive In Error
200E No Magazine
Diagnostics and Troubleshooting 6-9
Control Error Codes – 2xxx
Ctl. Invalid Command
An unsupported configuration was
detected.
One of the DLT drives was in an invalid
state This is caused by either
attempting to fetch a cartridge from an
empty drive, or stowing to a drive that
already has a cartridge loaded.
Currently not displayed.
An attempt to set the DLT SCSI id
failed.
An attempt to open a COM port failed.
An error occurred while attempting to
move the door.
While attempting to perform a MOVE
operation, the source or destination
locations were in the wrong state
(FULL or EMPTY).This also occurs if
the MOVE is attempted with an invalid
cartridge map.
A command was received while the
door was open.
A command was received while the
unit was in Menu mode.
An attempt was made to fetch a
cartridge from a drive that is not in the
unloaded state. This only applies
when the system is configured for
explicit unloads.
An attempt was made to access a
drive which is in an error state.
The element is not available because
the magazine is not installed.
continued