To operate the TL881 in Sequential Mode, the following configuration
parameters must be established:
Library Mode- change from Random (default) to Sequential DLT0
Sequential Mode must remain at Normal (default)
Test Unit Ready (TUR) - must remain at Custom (default)
To establish these parameters for Sequential Mode operation, proceed as
follows:
1. From the Default Menu press
6 appears:
Figure 4-6. Main Menu
2. Press
three times so that the
Enter.
The Configure Submenu shown in Figure 4-7 appears:
Figure 4-7. Configure Submenu
3. Press
twice so that the
. The Library Mode Selection Menu shown in Figure 4-8 appears:
Enter
Figure 4-8. Library Mode Selection Menu
4. Press
again so the
Enter
The Main Menu shown in Figure 4-
Enter.
SHR-1331
is next to Configure Menu and press
SHR-1332
is next to Set Library Mode and press
SHR-1461
is next to *Random.
Configuration 4-5