Compaq SW TL881 DLT Mini-Lib/1 Manual page 145

6-10 Compaq TL881 Minilibrary System Users Guide
Table 6-2
Fault Symptom Codes
continued
200F Removal Prevented
2010 Ctl Firmware Error
2011 Ctl Firmware Error
2012 Ctl Firmware Error
2013 Ctl Firmware Error
2014 Ctl Firmware Error
2015 Ctl Firmware Error
2016 Ctl Firmware Error
2030 DLT Timeout Error
2031 DLT Timeout Error
2032 DLT Timeout Error
2033 DLT Timeout Error
2034 DLT Timeout Error
204x Invalid Ctl Msg
Control Error Codes – 2xxx
Medium removal was attempted when
in a Prevent Removal State.
An invalid configuration was detected.
The configuration jumpers on the main
board may not be set properly.
A status block was received by the
Control Process operating in a Stand-
Alone or Slave configuration. Since
commands are never sent in these
modes, status cannot be received.
A command was received which was
invalid for the current configuration.
During powerup, communication with
one of the DLT drives was
unsuccessful.
While trying to update the front panel,
communication with one of the DLT
drives was unsuccessful.
Communication with DLT drive 1 was
unsuccessful (sequential mode).
Communication with DLT drive 2 was
unsuccessful (sequential mode).
While attempting to update the
cartridge map, communication with
one of the DLT drives was
unsuccessful.
An illegal message type code was
received. This can be the result of
receiving a NULL type code, a status
code without a command being active,
or a command code while a command
is currently active.
continued