Chapter 3 Commands; Command Summary - HP AlphaServer ES47 Cli Reference Manual

Chapter 3
Commands

3.1 Command Summary

Command
assign {component, memory}
bootline
build fru
clear {<envar>, alert, display, error, log,
port, srmenv}
config cables
connect
create partition
delete partition
deposit or d
disable {alert, remote, test}
el
enable {alert, remote, test}
examine or e
halt {in, out}
hangup
help
init modem
locate
logout
mbmboot or @
modify partition
power {off, on}
reset
save partition
Function
Assign resources to a partition.
Change the bootline used in boot ROMs.
Write FRU-specific information to a FRU's
EEPROM.
Clear the SPMU environment variable, the 'alert
pending' flag, all error fields in the specified
FRU, the screen or serial port, or SRM
environment variables for all partitions, for a
specific hard partition, or for a specific
subpartition within a hard partition.
Configure or assist cabling.
Connect to the system COM port of a partition.
Create a hard or subpartition.
Delete a hard or subpartition.
Write data to a memory location or CSR, IPR,
or I C device
2
Disable the sending of alerts, remote access, or
a diagnostic test
Event log - show the history of CLI inputs and
outputs.
Enable the modem dial-out alert function,
remote access to the system, or a diagnostic
test.
Read a memory location or CSR, IPR, or I
device.
Halt the entire system, CPU, or partition.
Terminate the modem or telnet connection.
Display the entire list of CLI commands.
Initialize the modem.
Locate the specified component (system
building block, PCI drawer, dynamic duo, or
power supply) by blinking its LEDs.
Log out of the remote host.
(Works only from the failsafe loader.) Boots the
main MBM/PBM image from flash or from the
network.
Changes the attributes of a hard partition.
Power off or on a system, component, or
partition.
Reset a system, CPU, or partition.
Save the partition data to the NVRAM.
Commands
C
2
3-1