Section 7. Installing Additional Adapters Drivers; Ethernet Adapter; Hp Netraid-1M Adapter; Troubleshooting - HP Tc2110 - Server - 128 MB RAM Installation Manual

Network operating system

Hide thumbs Also See for Tc2110 - Server - 128 MB RAM:

Table of Contents

Chapter 3

4. Open a command prompt window on your HP server (Start | Program |

Command Prompt) and verify the TCP/IP configuration you have set during

Windows NT installation by entering:

ipconfig /all

5. To verify the server and clients can communicate properly:

a. From one of the clients, open a command prompt and type:

ping computername

Where computername is the server name you entered during Windows

NT installation. You should get four reply's from your new server. If

there is a link problem it must be fixed before going any further.

You may test the link further by doing a ping between two clients at the

same command prompt, type:

ping other_client_IPaddress

You should get four replies from the second client.

b. Copy files back and forth from the clients to the server.

Section 7. Install Additional HP Accessories

The hp server tc2110 Startup CD includes the drivers for the following HP

accessories:

· HP-Intel 10/100 LAN

· HP NetRAID-1M adapter

· HP Surestore DAT24i

Please refer to the product manual enclosed with your accessory for the detailed

installation procedures.

This section will help you resolve some of the most common installation

problems.

Installing Microsoft Windows NT 4.0 Server

Table of Contents

Troubleshooting

Do you have a question about the Tc2110 - Server - 128 MB RAM and is the answer not in the manual?