Yamaha SRCD User Manual page 92

CHAPTER2 PROFIBUS Unit
(20) Point variable P definition ..................................................... Code 0114
The point variable P is set.
QWn+22
IWm+22
(Details)
Point number: A value of 0 to 999 can be specified.
(Example)
Transmission example 1:
The point variable P is set to 100.
Response example 1:
It is normally ended.
M E M O
M E M O
Since the point variable is prepared to treat the point number as the variable, a value
of 0 to 999 can be specified.
CAUTION
!
Though the content of the point variable is held even if the controller power
supply is turned OFF, the point variable is initialized to 0 if the program is reset
or the execution program switch or other operation which the program reset is
applied.
Command option
QWn+20 QWn+18
Command response
IWm+20 IWm+18
QWn+22 QWn+20 QWn+18
0000 0000 0000
IWm+22 IWm+20 IWm+18
0000 0000 0000
86
QWn+16 QWn+14
IWm+16 IWm+14
QWn+16 QWn+14 QWn+12
0000 0000 0064
IWm+16 IWm+14 IWm+12
0000 0000 0000
QWn+12
Point number
IWm+12
QWn+10 QWn+8
0000 0114
IWm+10 IWm+8
0000 0200