Input Power (Mains) Voltage Adaptation; Power (Mains) Cord Connection - Barco R9000740 Installation Manual

Power (mains) cord connection

Use the supplied power cord to connect your projector to the wall outlet. Plug the female
power connector into the male connector at the front of the projector.

Input power (mains) voltage adaptation.

Attention
The BARCOVISION 701 MULTIMEDIA - R9000740 leaves the factory to operate on
a mains (power) input of 230 Vac.
Adaptation of the power input of the projector from 230 VAC to 120 VAC or vice
versa is possible. Follow the procedure as described below.
Procedure
- Unplug the power cord from the power input on the front panel.
- Remove the front panel by loosening both retaining screws and take off the plastic
cover plate.
6-2
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX
FREQ
OFF ON
5975248 BARCOVISION 701 MULTIMEDIA 090497
POWER CONNECTION
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
5/2.5 AMP
60/50 Hz