POWER CONNECTION
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand
by mode', depending on the position of the 'power up' dip switch on the controller unit.
This DIP switch is set during installation by a qualified technician. If you want to
change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
Leds on the front plate of the projector
5975248 BARCOVISION 701 MULTIMEDIA 090497
AAAA
AAAA
AAAA
AAAA
6-5