Table of Contents
Advertisement
INSTALLATION ADJUSTMENTS
Loosen the four hexagon screws C, C',
Dand D', upper and lower fixation latch.
These screws fasten the cooling house
of the blue tube.
Pivot the blue CRT until the center of the
blue image coincides with the center of
the green image. If the angle of the red
CRT is corrected, tighten the four bolts.
After finishing the installation adjust-
ments procedure, the 'Path selection'
returns on the screen. You are now
able to start the alignment procedure
for the projector. You have the choice
between :
- Guided Adjustment Procedure
- Random Access Adjustment Proce-
dure
The result of both procedures will be
the same.
More explanation about
both procedures is given in the owners
manual.
The following page gives an overview
of the image corrections.
5975248 BARCOVISION 701 MULTIMEDIA 070597
blue crosshair
green crosshair
Move the bleu CRT
to the outside, away
from the green CRT
blue crosshair
green crosshair
Move the bleu CRT
towards the green
CRT
CRT
PROJECTION ANGLE
ADJUSTMENT
Align crosshairs
<ENTER> continue
<EXIT> to return
ENTER continues to the path selection
menu.
EXIT returns to the CRT projection an-
gle adjustment.
ADJUSTMENT MODE
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
Select with
then <ENTER>
<EXIT> to return
source 1
or
7-17
Advertisement
Table of Contents
