Power Connection; Power (Mains) Cord Connection; Input Power (Mains) Voltage Adaptation - Barco R9002380 Installation Manual

5

POWER CONNECTION

Power Connection

Power (mains) cord connection

Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front of the projector.
image 1

Input power (mains) voltage adaptation.

The BARCOCINE 7 - R9002380/81/82 leaves the factory to operate on a mains (power) input of 230 Vac.
The BARCOCINE 7 - R9002387/88/89 leaves the factory to operate on a mains (power) input of 120 Vac.
Adaptation of the power input of the projector from 230 VAC to 120 VAC or vice versa is possible. Follow the procedure as described
below.
1. Unplug the power cord from the power input on the front panel.
2. Loosen the 2 retaining screws of the front panel (image 1).
3. Pull out the module.
image 1
5976067 BARCOCINE 7 151299
See installation instructions before
connecting to the supply
OFF ON
See installation instructions before
V NOM 120/230 Volt
connecting to the supply
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
See installation instructions before
connecting to the supply
OFF
ON
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
Power Connection
5-1