6
POWER CONNECTION
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the front of the projector.
Input power (mains) voltage adaptation.
Attention
The BARCODATA 708 - R9002120 leaves the factory to operate on
a mains (power) input of 230 Vac.
Adaptation of the power input of the projector from 230 VAC to 120
VAC or vice versa is possible. Follow the procedure as described
below.
Procedure
- Unplug the power cord from the power input on the front panel.
- Remove the front panel by loosening both retaining screws and take
off the plastic cover plate.
- Pull out the module.
5975987 BARCODATA 708 260597
Power Connection
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX
FREQ
OFF
ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX
5/2.5 AMP
FREQ 60/50 Hz
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX
FREQ 60/50 Hz
OFF ON
5/2.5 AMP
60/50 Hz
5/2.5 AMP
6-1