Ip Phone Startup Verification; Network Settings - Cisco 8831 Administration Manual

Cisco Unified IP Conference Phone 8831 installation

IP Phone startup verification

After the conference phone has power connected to it, it begins the startup diagnostic process by cycling
through the following steps.
1 The specified LED buttons flash on and off during the various stages of boot up as the conference phone
checks its hardware. See the following table for a list of the hardware test and the LED diagnostic status.
Table 17: LED diagnostic status
2 The screen displays the Cisco Systems, Inc., logo screen.
3 The screen displays the Revolabs, Inc., splash screen
4 This message appears as the conference phone starts up.
5 The home screen displays:
If the conference phone successfully passes through these stages, it has started up properly. If the conference
phone does not start up properly, see

Network settings

If you are not using DHCP in your network, you must configure these network settings on the conference
phone after installing it on the network:
• IP address
• IP subnet information (subnet mask)
• TFTP server IP address
• You also may configure the domain name and the DNS server settings, if necessary.
Hardware Test
Power is Ready
Flash is Accessible
RAM Test Successful
Ethernet Test Successful
• Phone is not registered
• Current date and time
• Primary directory number
• Softkeys
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
Sound Base LEDs
Green LEDs flash
Green LEDs flash
Green LEDs flash
—
Startup problems, on page 123.

IP Phone startup verification

DCU LEDs
Red and Green LEDs flash
Red and Green LEDs flash
Red and Green LEDs flash
—
55