Link Conference Phones - Cisco 8831 Administration Manual

Unified ip conference phone unified communications manager 9.0
Hide thumbs Also See for 8831:
Table of Contents

Advertisement

Features, templates, services, and user setup
When using a Sound Base in Linked Mode, the primary base unit must be connected using the
Caution
CP-PWR-CUBE-3 external power supply.
If two devices are linked after both are registered, the user can select which is the primary device.
A secondary device receives upgrades to firmware seamlessly from the primary device.

Link Conference Phones

Use a daisy cable to connect two sound base units in Linked mode. This procedure describes the best practice
for connecting the two units.
Procedure
Step 1
Connect the DCU to the conference phone to be used as the primary unit.
Step 2
Connect the network cable to the conference phone to be used as the primary unit.
Step 3
Connect the power cable to the primary device and plug into a wall plug.
The secondary Sound Base does not need to be plugged into external power, but in Linked Mode the primary
unit must be connected to external power.
Step 4
Use the provided daisy cable to connect the primary unit to the secondary sound base.
Voice, dial tone, ringer and base LEDs synchronize between the two units.
Related Topics
Linked Mode, on page 100
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
Link Conference Phones
101

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents