Set Admin Vlan Id; Ipv4 Setup Menu Options - Cisco 8831 Administration Manual

Set Admin VLAN ID

Set Admin VLAN ID
Procedure
Step 1
Choose Apps > Admin Settings > Network Configuration > Admin VLAN ID.
Enter your password at the prompt.
Step 2 Enter a new Admin VLAN ID.
Step 3
Press Apply, and then Save.

IPv4 Setup menu options

The IPv4 Setup menu is a submenu of the Network Setup menu. To reach the IPv4 Setup menu, select the
IPv4 option on the Network Setup menu.
The following table describes the IPv4 Setup menu options.
For information about the keys you can use to edit options, see
61.
Table 19: IPv4 Setup menu options
Option
DHCP
IP Address
Subnet Mask
Default Router 1
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager
9.0
64
Description
Indicates whether the conference phone has
DHCP enabled or disabled.
When DHCP is enabled, the DHCP server
assigns the conference phone an IP address.
When DHCP is disabled, the administrator
must manually assign an IP address to
the phone.
For more information, see DHCP
Internet Protocol (IP) address of the
conference phone.
If you assign an IP address with this option,
you must also assign a subnet mask and
default router. See the Subnet Mask and
Default Router options in this table.
Subnet mask used by the phone.
Default router used by the phone (Default
Router 1).
Cisco Unified IP Conference Phone 8831 settings
Value input and editing guidelines, on page
To Change
Set DHCP, on page 65
usage.
Set IP address, on page 66
Set subnet mask, on page 66
Set default router, on page 67