Interaction; Cisco Unified Ip Conference Phone 8831 And Cisco Unified Communications Manager Interaction; Cisco Unified Ip Conference Phone 8831 And Vlan Interaction - Cisco 8831 Administration Manual

Interactions with other Cisco Unified IP telephony products
Cisco Unified IP Conference Phone 8831 and Cisco Unified Communications Manager

interaction

Cisco Unified Communications Manager is an open and industry-standard call processing system. Cisco
Unified Communications Manager software sets up and tears down calls between IP devices, integrating
traditional private branch exchange (PBX) functionality with the corporate IP network. Cisco Unified
Communications Manager manages the components of the IP telephony system—the conference stations, the
phones, the access gateways, and the resources necessary for features such as, call conferencing and route
planning. Cisco Unified Communications Manager also provides:
• Firmware for conference stations and phones
• Authentication and encryption (if configured for the telephony system)
• Configuration file using the TFTP service
• Conference phone registration
• Call preservation, so that a media session continues if signalling is lost between the primary
Communications Manager and a conference phone
For information about configuring Cisco Unified Communications Manager to work with the IP devices
described in this chapter, see Cisco Unified Communications Manager Administration Guide, Cisco Unified
Communications Manager System Guide, and Cisco Unified Communications Manager Security Guide.
If the conference phone model that you want to configure does not appear in the Phone Type drop-down
Note
list in Cisco Unified Communications Manager Administration, go to the following URL and install the
latest support patch for your version of Cisco Unified Communications Manager:
http://www.cisco.com/cisco/software/navigator.html?mdfid=282677102&i=rm
For more information, see "Software Upgrades", Cisco Unified Communications Operating System
Administration Guide
Related Topics
Cisco Unified IP Conference Phone 8831 security features, on page 20
Available telephony features, on page 76

Cisco Unified IP Conference Phone 8831 and VLAN interaction

When Voice VLAN (VVLAN) is disabled, the egress SW port packets are not tagged and only untagged
packets are accepted on the ingress direction.
When VVLAN is configured as 1-4094, the egress SW port packets are tagged with the VVLAN. For ingress
packets, if VLAN is different from VVLAN, only the packets that match the VVLAN are accepted. If VLAN
equals VVLAN then both packets that match the VVLAN and untagged packets are accepted.
When VVLAN is set to 0, 802.1p is enabled. The egress SW port packets will be tagged with 802.1p. On the
ingress side, both 802.1p tagged packets and untagged packets are accepted.
For more information, see the documentation included with a Cisco switch. You can also access switch
information at this URL:
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager
9.0
36
http://www.cisco.com/en/US/products/hw/switches/index.html
Cisco Unified IP Phones and telephony networks