Release Dhcp Address; Dhcp Usage; Set Up Ip Phone To Use Dhcp; Set Tftp Server - Cisco 8831 Administration Manual

Cisco Unified IP Conference Phone 8831 settings

Set TFTP Server 2

Procedure
Step 1
Unlock options.
Step 2 Choose Apps > Admin Settings > Network Configuration > TFTP Server 1.
Step 3 Press Edit and enter an IP address for the TFTP Server 1 option.
Step 4 Press Apply, and then press Save.
Step 5
Choose Apps > Admin Settings > Network Configuration > TFTP Server 2.
Step 6 Choose the TFTP Server 2 option, and then press Edit.
Step 7 Enter a new backup TFTP server IP address.
Step 8 Press Apply, and then press Save.
Related Topics
Unlock and Lock Options
Set TFTP Server 1, on page 68

Release DHCP address

Procedure

DHCP usage

Dynamic Host Configuration Protocol (DHCP) automatically assigns IP addresses to devices when you connect
them to the network. Conference stations enable DHCP by default.
If you are configuring the Ethernet network settings on the phone for an IP network, you can set up an IP
address for the phone by either using DHCP to assign it for you or by manually entering an IP address.
You must also enter the domain name for the phone in the Ethernet Setup page.
Note

Set up IP Phone to use DHCP

To enable DHCP and allow the DHCP server to automatically assign an IP address to the Cisco Unified IP
Phone and direct the phone to a TFTP server, perform these steps:
Cisco Unified IP Conference Phone 8831 Administration Guide for Cisco Unified Communications Manager 9.0
Set TFTP Server 2
69