Oce Arizona 550 GT User Manual page 137

User Manual: Arizona 550 GT - Version 1.2, Revision B - 2012
Bend the height adjustor (small triangle in the top corner of the edge protector) slightly
3.
and then straighten it again. This results in a slight bend (no more than a media thickness),
that allows the media edge to move more freely under the protector.
Attention:
If the height adjustor area is higher than 1 mm from the platen, there is a possibility that
the carriage may hit the edge of the protector and thus damage printhead nozzles.
Place the bent edge of the protector into the media cut guide.
4.
Note:
Do not let the plastic edge near the arc butt up against the media edge or the device may
not let the media pass smoothly.
The vacuum in the platen will hold the main part of the protector in place while the image
is printed.
Slide the protector towards the media edge until the inside edge of the height adjustor is
5.
positioned over the media edge. If plastic bows slightly at the edge guide side, adjust the
flap angle as described in Step 2 until it lies flat.
[95] Media Protector
Result
The media edge protectors will reduce the amount of fiber and other debris. However,
it is important to keep the platen and cutting guide areas clean as indicated in the Roll
Media maintenance section.
How to Deal with Wide Media
Chapter 7 - How to Operate the Roll Media Option
How to Use Media Edge Protectors
137